K7 Hybrid

Length

19.5 cm

Creator

iMatt

Insert

Yes

Materials

• Pilot G3 (plastic-tip version) (barrel, grip & tip): 1
• Hi-Tec (tip): 1
• Hyperjell (grip): 1
• HGG (tip): 1
• Japanese Jimnie (cap): 1 (Japanese Jimnie)
• Signo Dx (grip, metal tip): 1
• Signo Broad (grip, metal tip): 1
• Optional: 3 Penwish rings

Steps

Step 1

Remove the grip of your G3 and file the front and the lower part of the tip

Step 2

Add the Hi-Tec C and Signo tips onto the G3 tip, as on the Kuzu mod (G3 tip > Hi-Tec C tip > Signo tip)

Step 3

Take all the grips off. Cut 1 cm of the Signo Broad grip and 0.9 cm of the Hyper Jell grip. The Signo DX grip doesn’t need cutting.

Step 4

Cut the clip of the Jimnie cap off completely (sand down what’s left after cutting).

Step 5

Put the grips on the front of your G3 like this:
ring > 0.9 cm Hyper Jell grip > ring > 1 cm Signo Broad grip > ring > Signo DX grip.
*“Ring” means a Penwish ring, an O-ring or similar.
*After the third ring, wrap 2 turns of electrical tape around the rest of the front, then add the Signo DX grip

Step 6

Fit the last Signo tip onto the HGG tip (HGG tip > Signo tip)

Step 7

Put the two tips into the Jimnie cap

Step 8

Cut 0.3 cm of Signo Broad grip and push it into the cap right after the tips.

Step 9

Push the rest of the Hyper Jell grip into the Jimnie cap

Step 10

Finally, add a bit of electrical tape to the back of the G3 and put the Jimnie cap on.

Done.

Comment (original author):
A beautiful mix between Seven’s G3 mod and Kuzu’s G3 mod 😀

Photos: Unknown