Watto g3 mod

Length: 20 cm
Weight: 14 g
Creator: Watto
Insert: Yes

Materials

G3 (barrel, grip, cap): 1
G3 (rubber part inside the cap): 2
Playcolor (barrel): 1
G2 (grip): 1
Hyperjell (cap, grip): 1
anyball (grip): 1
airbalance (grip): 1
Sailor IC liquid gel (grip): 1
Diaso Gel roller (rubber part inside the cap, tip): 1
Bic round stic (backplug): 1
Airfit BA-9 (ring): 1
Kokuyo Fit Curve (Metal ring): 1
HGG (tip): 1

Steps

Step 1

Prepare the front of the G3 barrel

Step 2

Cut 5 mm of Hyper Jell grip

Step 3

Fit a BIC backplug onto the Gel Roller tip

Step 4

Put the part from step 3 onto the Hyper Jell grip

Step 5

Cut 1.2 cm of barrel from the back of the PlayColor 2

Step 6

Cut 2.7 cm from the front of the PlayColor 2
Note: not including the part inside the cap (see photo)

Step 7

Cut 1.2 cm from the front of the G3 cap

Step 8

Poke holes through the middle of the rubber parts from two G3 caps

Step 9

Put one of the rubber parts from step 8 inside the HGG tip

Step 10

Put the tip from step 9 on the front of the barrel cut in step 6

Step 11

Put the front-most block of Anyball onto the PlayColor 2 barrel, then the cut piece of G3 cap, and at the front an Air Fit ring and one block of Supergel grip

Step 12

Put 1.6 cm of Airblanc grip over the PlayColor 2 piece from step 5 and attach it in front of the part from step 11

Step 13

Put 4 blocks of G3 grip between the two PlayColor 2 pieces from step 12
Note: Vore-Tex’s tutorial recommends leaving the G3 grip inside a Dr. Grip grip for a day so it shrinks and fits more easily